This allows you to make a button that clips to my SMDs picking tool for the Slurp'nPick+ station (https://youtu.be/mOqiC4d56NU)

There are two files, one is the button housing that clips to the picking tool and the other is a clip that holds the wire and the air hose together, atleast 8 of these are recommended.

A momentary push button (6x6mm) is required (can be SMD or THT just cut or bend the pins if necessary), use a piece of electrical tape to cover the back of the button as shown in the pictures. You will also need a cable with a 3.5mm audio plug on the end, you can find the pinout in the instructions of the station.The hole for the cable fits a 3mm diameter cable.

This has only been tested with a resin printer and I doubt it has the necessary tolerances for an FDM printer. Print with the flat button side facing the build platform.