This is my wooden coffin I made for Halloween.

It had wooden tectures on outside, so it looks like real wood. I printed it in PLA brown, but woodfill would be even more realistic.

The skeleton has movable joints, which makes it fun to assemble and pose in different ways

Slicer settings (included in the print profile):

I recommend 0.12 mm layer height (or better: 0.8 mm) for more realistic wooden textures. The coffin lid requires supports. I added a color change to print the cross and the top outer edge in a different color. Because of the color change on the lid, it's best to print on two plates.

I had to use brim for the skeleton, and it was easy and satisfying to remove. But you may not need it if your build plate is clean enough.

Please see here if you require assembly instructions: Poseable Skeleton Army It's very similar to the Dummy 13 figurines.

The coffin is 100% my own creation, and the skeleton was made by Gabriel Rosiak and shared under the CC BY 4.0 license.

Poseable Skeleton Army © 2024 by Gabriel Rosiak is licensed under Creative Commons Attribution 4.0 license.

Under the CC BY 4.0 license, you are free to share and adapt this work, including for commercial purposes (such as selling prints), provided that you give proper attribution. 

Wooden textures was added with the help of bumpmesh.com, by CNCKitchen