This fully articulated ferret prints instantly and requires no assembly.  Each joint pops right off the bed, ready to twist, curl and wiggle just like a real ferret.  The segmented body allows it to coil up on a desk or drape over a monitor edge. It’s a lovely choice for wildlife enthusiasts, fidgety hands needing something to hold or anyone curious about print-in-place mechanisms.

Give the model a gentle wiggle while it’s still warm from the bed to loosen the joints.  Available in two colourways – soft cream and warm cinnamon rust – you could print one of each and display them together like in the photos or build a little ferret family over time. It’s also a sweet, low-cost gift for animal lovers and a great small test print for experimenting with AMS colour swaps to create subtle shading along the body.

Filament Colour & Material

PLA is the way to go here. It holds the joints crisp and keeps them free moving, whereas PETG's extra stringing can weld print in place segments together. A soft cream or ivory suits the pale ferret colouring, while a warm cinnamon or rust brown matches the sable tone shown in the photos.

Print Settings

• Print in place, no supports
• Wall line count: 2 or more
• Infill: 15%
• Layer height: 0.16mm
• Line width: 0.6mm (default, initial, and outer walls)

Feel free to print this one for yourself or as a gift. If you want to sell prints or use it commercially, you'll need the Commercial Licence tier over on Patreon:

https://www.patreon.com/c/FolkandForge