After looking around I couldn't find a perfect gimbal/stick protector for my new and expensive DJI FPV Controller 3, so I decided to create my own.

I designed it so you will not need supports to print it (print it "upside down" refer to the 5th photo) and so it can use the geometry of the gimbal and surrounding area to stabilize the sticks in place.
I also added small ribbing to the middle piece so you can take the protector off easily.

Settings I used to print:
Layer height: 0.12mm
Nozzle: 0.4mm
Filament: Gray PETG
Walls: 3
Brim: No brim
Support: No support
Infill: Gyroid 15%