Stealth Fighter F-117 Nighthawk

Nighthawk Fighter—F117

Single cockpit, movable wings and canopy; glue is required for assembly.

This is a highly detailed model that has been optimized for easy printing. The model has been specifically tailored for 3D printing.
Printing Tips:
Print Bed: Use a textured PEI bed.
Material: PLA
Layer Height: 0.12 mm
Outer Wall Count: 2
Acceleration: Set all acceleration values to 1000 mm/s² or lower.
Important Notes:
Due to material shrinkage and printing tolerances, some sanding and gluing may be necessary. Apply even pressure when assembling parts.
Before printing, thoroughly clean the PEI print bed to ensure good adhesion, and make sure your filament is dry.
Special thanks to all friends for your attention, likes, downloads, and support!

============================================================================

Single cockpit, movable wings and canopy, glue required for assembly.

placed and taken out.

Printing Tips:

Print Bed: Use a textured PEI sheet.

Material: PLA

Layer Height: 0.12mm

Outer Wall Count: 2

Acceleration: Set all acceleration values to 1000 mm/s² or lower.

Important Notes:

Some sanding and gluing may be required due to material shrinkage and printing tolerances. Apply even pressure when assembling parts.

Before printing, thoroughly clean the PEI print bed to ensure good adhesion, and ensure your material is dry.

Special thanks to all friends for your attention, likes, downloads, and support!

USS George H.W. Bush, the tenth and final Nimitz-class aircraft carrier built for the United States in the early 21st century.