Artwork source: Alienart, then used HueForge v0.9.3 to create the model.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm.

You may print at higher layer heights below the Min Depth of 0.48mm. The Max Depth is 2.24mm and the Actual Depth is 2.164mm.

In print profile is modesl size 150x150mm, you can modify the X and Y dimensions. Do not adjust the height (Z) in your slicer! The layers would not be correct. 

It is possible to print without material system by manually changing the filament (setting filament change or pause) in the slicer, depending on your printer and sw support.

Filaments Used:
PLA Elegoo+ Black Transmission Distance: 0.3
PLA BambuLab Basic Blue Gray  Transmission Distance: 3
PLA Elegoo + Orange  Transmission Distance: 6
PLA Elegoo Basic White  Transmission Distance: 7
This print uses 5 unique filaments

Swap Instructions:
Start with Black
At layer #7 (0.64mm) swap to Blue Gray
At layer #12 (1.04mm) swap to Orange
At layer #16 (1.36mm) swap to Yellow
At layer #21 (1.76mm) swap to White (or again Blue Gray) for the rest. 

• with the white filament is the main cover photo, check the second one - Blue Gray version. 

*  Info For Centauri Carbon!!!  Officially supports a layer height of 0.1mm - but in system 0.08 (adaptive layer value). So you can set it for printing and everything works correctly!