Plant nametag
Print Profile(1)
- 0.2mm layer, 2 walls, 15% infill
1-disc
PLA
Designer
17
13
Released 2025-10-20
This is a nametag for a plant. You can use either side. if pen rubes off try using a differnt pen or put some masking tape down.
Originality of the Model
The author declares that this work is their personally original model
This model is licensed under the following terms:
No Copyright.
Models(2)
- plant nametag.3mfDesigner
31.54 KB
2025-10-20
plant nametag.stlDesigner25.67 KB
2025-10-20
No more
