Updates over on Printables: https://www.printables.com/model/1442509-centauri-carbon-panel-riser-10mm

Elegoo Centauri Carbon compatible panel riser for internal spool mod. 

Panel is raised by 10mm to allow for internal spool mounting and prevent bed from crashing into the spool holder.

Hardware needed:

• 12mm M3 Screws (8 pcs) (can be slightly longer I believe)
• (optional) CA glue for easier assembly and more rigid panel

I wanted to make a simple, panel riser that does not require any special tools, like heat inserts. Some very small gaps are presents between joints. First print seen in the picture had too large roundings in the panel edge inlay, I have fixed that now. I did not use any glue as I found that the panel held together just fine when installing it (this depends on how tight the pins print out).

Printing: Separate models in slicer by right clicking the riser and selecting “Split” → “To objects”.

Settings I used to print with PETG:

• Elegoo Centauri Carbon Stength profile with following adjustments:
  • Infill to cubic (20%)
  • Wall loops to 4
  • Top and bottom shell layers to 4
  • Print sequenze by object
  • Brim type to No-brim
  • Elephant foot compensation to 0.2 and 2 layers

Please provide feedback, especially on the roundings of the corners allowing the panel to sit snuggly. Testing this myself takes a lot of time to print and reinstall, so I'd appreciate somebody else confirming the changes working.

Changelog:
CentauriCarbonPanelRiser_121025a: Initial release
CentauriCarbonPanelRiser_121025b: Adjustments to pin tightness and rounding of corners