holder
tray
dispenser
organization
office
large
post it
postit
sticky note
post it note
- 3 plates, with/without pen holder
3-disc
PLA
Designer
19
9
I always have a ton of Post-It notes on hand, but most of the holder models I found are fairly short, or use a good amount of filament.
This one is designed to look nice, use a small amount of filament (about 40 grams for the ones with a pen holder), and be able to hold an above-average number of Post-It's (the interior is about 2in/50mm high). It's specifically designed for Post-It's that are 3in x 3in (76mm x 76mm)
Print profile has THREE PLATES to choose from, only print the one you need: PEN HOLDER ON LEFT SIDE, PEN HOLDER ON RIGHT SIDE, or NO PEN HOLDER.
Originality of the Model
The author declares that this work is their personally original model
This model is licensed under the following terms:
Credit must be given to the creator
Only noncommercial uses of the work are permitted
Models(1)
- Sticky Note Holder.3mfDesigner
474.95 KB
2025-09-20
