Ania
- 0.2 mm layer height, 2‑wall walls, 15% infill density
1-disc
PLA
Designer
1
0
The Magical Child Reborn—Anya Descends
The skin‑colored filament has arrived; time to print another half‑grown figure—0–0. It’s a pity I can’t draw eyes, but she’s absolutely adorable…
Be sure to use a high‑adhesion build plate, as the model features a large number of supports. While we’ve configured the supports with easy‑removal settings, their structural integrity is somewhat compromised—so it’s best to apply adhesive spray.
When removing the supports, use gentle, precise movements rather than brute force—about three minutes should be enough to take them all down.
Originality of the Model
The author declares that this work is their personally original model
This model is licensed under the following terms:
Credit must be given to the creator
Models(1)
- 魔童阿尼亚.3mfDesigner
8.98 MB
2025-09-02
