Hydroplane (Non-Jet Version) V1

1. For printing the model, prioritize using ABS, ABS+, or PETG materials; avoid brittle filaments like PLA.

2. Required components include a brushless motor (2312S brushless motor), a waterproof drive shaft (with an outer sleeve diameter of 8 mm) in the 150–200 mm length range, a universal joint connector (ensure proper alignment with the motor and drive shaft dimensions), an electronic speed controller, a remote control and receiver, a power switch, nine 18650 batteries configured in either 2S or 3S series, M3 screws, and an adequate supply of wiring cables.

3. The model is not to be distributed externally; it may only be downloaded from this platform.