Three different kind of luggage holders for in the trunk of your car to keep your luggage from sliding around.

• Classic, inspired by the version you can buy at many different places. Great for keeping tall bags from falling over or sliding around.
• Medium, a medium sized holder with an easy handle for pulling it loose.
• Corner, a small sized holder great for keeping boxes or crates in their place. With “finger holes” so you can easily pull it loose.

Print instruction
Since it can get pretty hot inside a car you probably should not print this in PLA.

• Use at least 3 walls for strength
• Print without supports
• The classic version can be printed on its side which is probably stronger (but maybe unnecessary). You do need to beware of warping though, add a brim if necessary. You can also print it on its back, which is easier and quicker, but probably less strong.

Assembly
Simply add some self-adhesive (or glue yourself) Velcro to the bottom. I used 2cm wide strips.