Description:

A painting of the singer Vasco Rossi created using Hueforge software, at the request of a friend who is a fan of the singer.

Printing Instructions:

No support is required (although Bambu Studio can advise if one is needed); I activated the brim tabs on the corners to increase the painting's adhesion. If the print profile is not set correctly or you prefer to set it manually, below are the instructions provided by the Hueforge software:

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.2mm

The Model is 156.5x200mm in size 
You may print at higher layer heights below the Min Depth of 0.28mm 
The Max Depth is 3.4mm and the Actual Depth is 3.5mm

Filaments Used: 
PLA PolyLite Black Transmission Distance: 0.3 
PLA BambuLab Basic Blue Gray Transmission Distance: 3 
PLA PolyLite Gray Transmission Distance: 1 
PLA PolyLite White Transmission Distance: 5 
This print uses 4 unique filaments

Swap Instructions: 
Start with Black 
At layer #11 (1mm) swap to Blue Gray 
At layer #25 (2.12mm) swap to Grey

Border Only Colors from here until the end.

At layer #33 (2.76mm), swap to White for the rest.

Assembly Instructions:

No assembly required, as the model is made in one piece.

Post-Processing:

There may be some stringing on the surface; a quick blow-dry with a hairdryer or lighter should remove it.