A limit switch mount i made up for use on V-Slot extrusions. Two versions included, one uses 2 screws and T Nuts, the other uses 1 screw and 'clips' around the slot, as well as a small zip tie.

The simpler, 2 screw, version was the first I made, but I didnt really see why i needed to use 2 screws for 1 switch, so i made the second version. For this first, youll need put the limit switches on, then melt the posts down to hold it in. Is it strong? Meh, I gave them a few tugs and they didnt move.

The second one, requires 1 screw, and a zip tie. I wanted to use the same melted post design, but simply couldnt find a way to easily print it without supports, so I decided on the zip tie route.

STEP files included if you wish to modify this for yourself.