Source of the gauntlet structure: @Miss crow's snack pack

I remade the entire exterior model as well as the rivet model.

I significantly optimized the rivet structure, greatly improving both printing success rates and assembly success rates.

Tools you’ll need: a pair of flat-nose pliers (using flat-nose pliers to install the rivets will save you a lot of time).

I applied negative part processing to all the plate components, allowing you to freely adjust the size of the holes.

Please test the fit between the rivets and the holes before printing.

If you need to print the right hand, print disc 05 and remove any duplicate parts, then repeat printing discs 01–04. If you only need the left hand, simply print discs 01–04.

The largest rivet on the left side secures the main gauntlet section; the smaller rivets in the middle connect the fingers; and the biggest rivet on the right links the thumb to the arm guard.

Assembly tutorial images:

(I originally planned to submit this for a competition, but ended up spending far too long on it 😇)