Single Razor Holder
Print Profile(1)
- 0.2mm layer, 3 walls, 10% infill
1-disc
PLA
Designer
1
0
Released 2026-07-24
This is a razor holder that pops on to your shaving cream can. It is lightweight, so may loose grip over time, but you could use some tape or glue to keep in in place if needed.
Originality of the Model
The author declares that this work is their personally original model
This model is licensed under the following terms:
Credit must be given to the creator
Only noncommercial uses of the work are permitted
Remixes must be shared under the same license
Models(1)
- Razor Holder (single).3mfDesigner
87.16 KB
2026-07-22
No more
