- 0.2mm layer, 2 walls, 10% infill
5-disc
PLA
Designer
4
0
This is a Simple Magnetic Tool Holder
Common Steel Tools like Screw Drivers , Scissors and Pliers easily stick to the Magnets Hidden Away in the Top of the Loops
Easily Pulled off and put back ( See Gif )
Comes With 3 Bases , and 2 Loop Sizes for Longer or Shorter Tools
This Holder Needs Up to Six 10x3mm Round Magnets , Each Hoop has 3 Slots , Each slot Takes Two 10x3mm Magnets , Might be able to use just 1 per Slot if Using smaller tools or something like Paper clips
They Friction Fit in Well , but some glue not a bad idea
Bill of materials
- NameQuantityNotes
- 110x3mm Round Magnets61-6 Magnets Depending on Desired tool size / amount , 6 is Recommended
Originality of the Model
The author declares that this work is their personally original model
This model is licensed under the following terms:
Credit must be given to the creator
Only noncommercial uses of the work are permitted
Remixes must be shared under the same license
Models(1)
- Magnetic Tool Holder.3mfDesigner
3.95 MB
2026-07-19
