pot
pen holder
car
pen
wheel
pencil holder
car wheel
Wheel Pen Holder
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
1-disc
PLA
Designer
13
2
Released 2026-01-13
This is a super easy to print car wheel themed pen holder ! No supports needed, no raft, no special infill, just print it flat or like what suits you the best
You may need glue, I did'nt need some ( just press fit, and it stays perfectly ) it may vary depending on your printer tolerances
Originality of the Model
The author declares that this work is their personally original model
This model is licensed under the following terms:
Credit must be given to the creator
Only noncommercial uses of the work are permitted
Models(2)
WheelPenHolder.3mfDesigner
996.80 KB
2026-01-12
- Tyre (1)_0.2mm_PLA_MINIIS_1h47m.gcode.3mfDesigner
1.09 MB
2026-05-25
No more
