Fixture
Support
Adhesion
- 0.2 mm layer height, 2‑wall walls, 15% infill density
1-disc
PLA
Designer
12
1
Who else has struggled with trying to glue 3D-printed parts together using 502 adhesive—only to end up with sore hands from constant gripping, yet still failing to achieve a secure bond? This nifty little jig I just whipped up is designed to tackle that exact pain point: Simply slide the two parts you want to join into the jig, and the built‑in toothed mechanism locks them firmly in place—no more fumbling with your fingers! While the 502 adhesive is curing (a matter of just a few minutes), you can easily take a break to catch up on emails or start tweaking your next model.
- ✅ Compatible with most small printed components for seamless assembly
- ✅ Easy to print—just use PLA filament and you’re good to go!
- ✅ Reusable time and again without worrying about wear and tear
Originality of the Model
The author declares that this work is their personally original model
This model is licensed under the following terms:
Credit must be given to the creator
Only noncommercial uses of the work are permitted
Remixes must be shared under the same license
Models(1)
- shapr3d_export_2026-01-02_09h10m.3mfDesigner
468.96 KB
2026-01-02
