WHY?
This is a simple and sturdy trash bag dispenser I designed for our home, under the kitchen sink. 

WHAT?
There are two versions: Standard or Large.
The connectors are used for either the large or standard model housing. There are also whole trays available for download.

For a version suitable for 200mmx200mm print volumes or “no-support” version..
200mm x 200mm Print Bed Models:
https://www.nexprint.com/en/models/1990121130903683072

WHEN?
Large tray, about 15hrs
Standard tray, about 13hrs

HOW?
- Install using four(4) wood screws, as described below. Point the middle curved part of the hole, on the housing piece, is pointing toward the wall (as pictured)
- Grab the bag from the bottom and pull up-and-out away from the dispenser. 
- These are the recommended print settings:

Note: If not specified, and aside from specific filament settings, all other settings not mentioned are the Orca Slicer defaults for a .4 nozzle Centauri Carbon. Also, pictured models are Inland PLA Basic (they source from eSun, and Polymaker for tougher filaments), and they are plenty strong enough.

Housing
Material: Any 
Infill: 100%
Support: Yes, Tree

Brackets
Material: Any
Infill: 25%
Support: No

Connectors/Fasteners
Material: Any
Infill: 25%
Support: No

Non-Printable Hardware
16-20mm (¾"-1¼") Wood Screws x 4