A Like, Rating or Comment is a huge help and I really appreciate all of it. 🙏

Want to support my work? 
You can buy me a coffee and support my work here: https://ko-fi.com/mikegyverminis

Commercial Licensing is also available here as well to sell all of my models
 

Looking for More DnD Minis?

Check out the whole collection with new ones added all the time.

==========================================================

DnD TTRPG Grick Miniature

Slithering from rocky crevices, the grick is a terrifying ambush predator: a camouflaged, worm-like monstrosity with a wicked beak and four lashing, barbed tentacles that snap out to ensnare and crush its prey. These adaptable horrors are often found clinging to cavern ceilings, dropping silently upon their unsuspecting victims.

Nozzle: 0.4

Layer Height: 0.08mm

**This print has been tested multiple times on an X1C and P2S successfully, results may vary if printed on a different printer (bedslinger or another CoreXY)**

Post Processing: Post Processing: Use thin tweezers to Pull supports down and out after cutting from the brim/base first. Be careful around the tentacles as they are thinner than the rest. These just need extra care and patience.  Work from Bottom to Top. Some smoothing (sanding etc) after the supports are removed, may be required. 

Housekeeping: Make sure your printer is Calibrated, Build Plate washed and Filament Dried so the supports have the best adhesion possible. Let the miniature fully cool down before removing supports.