Clip
Bag
- 0.2mm layer, 3 walls, 100% infill
1-disc
PLA
Designer 
Elegoo Centauri Carbon, PETG, 0.2mm layer, 3 walls, 10% infill1-disc
PETG
Designer5(1)
108
32
I wanted a bag clip that needs only printed parts and that has a wide surface to properly seal the bag.
There is not a lot of options that meet this criteria, so i decided to design it myself. I hope that it can be useful for everyone else too.
I suggest to use PETG for the spring and PLA for the other part. But personally I used PLA for everything and it works perfectly
Print without support and i suggest 100% infill even if on the flat part of the clip is not necessary
Originality of the Model
The author declares that this work is their personally original model
This model is licensed under the following terms:
Credit must be given to the creator
Only noncommercial uses of the work are permitted
Models(4)
Clip_1.STLDesigner
982.50 KB
2025-10-01
Clip_2_V2.0.stlDesigner778.40 KB
2025-10-01
- All.3mfDesigner
645.75 KB
2025-10-01
- Flat bag clip_ECC.3mf
653.48 KB
2026-02-04
View all(4)
