- 0.2mm layer, 2 walls, 10% infill
1-disc
PLA
Designer
4
2
Halloween tealight lighting design in the form of a Jason mask carved into a pumpkin. The flashlight is intended only for the electronic LED tea light. I use a 40mm diameter LED candle.
I recommend using supports
When using PLA, the flashlight can be used indoors, or when using PETG, it can be used outdoors in the garden.
Size 86 x 80 x 81 mm
If you have any idea about the theme of decoration, contact me in messages.
I would be very happy to share pictures of your prints on this site.
Check out my other creations and don't forget to follow me so you don't miss any news.
If you are interested in a commercial license, you can join the printables club↓
https://www.printables.com/@kutnohormac_1532170
You can support me by buying a coffee ↓
https://buymeacoffee.com/kutnohormac
Originality of the Model
The author declares that this work is their personally original model
This model is licensed under the following terms:
Credit must be given to the creator
Only noncommercial uses of the work are permitted
Remixes must be shared under the same license
Models(1)
- Jason pumpkin.3mfDesigner
345.48 KB
2025-09-23
