Here's another beautiful (if I may say so myself) HueForge Hybrid print for you!

I used Burnt Titanium for the 'space blue' and it turned out magnificently, but you can use whatever you feel like, honestly! Same goes for the material for the TIE Fighter. I just wanted to try out the Metal PLA that Bambu sent me :)

This print takes 3 hours on the Bambu Lab P1P and is completely printed in place without any supports. If you are using a Bambu printer or Bambu studio, the 3MF will have all the necessary settings you need. If not, please download the STL and follow the instructions below!

Print Instructions: HueForge section of the print (0.00mm - 2.00mm)

• Print at 100% infill with a layer height of 0.04mm with a base layer of 0.24mm

TIE Fighter part of the print (2.04mm - 64.44mm)

• Print at 0.16mm layer height, with 2 walls, 3 tops and 3 bottom surfaces

• I used 5% gyroid infill.

Filaments Used:

• PLA Kingroon Black Transmission Distance: 0.4

• PLA Flashforge Burnt Titanium Transmission Distance: 5

• PLA CC3D Lemon Yellow Transmission Distance: 8

• PLA BambuLab Basic Jade White Transmission Distance: 5

• PLA Bambulab Metal Iron Gray Transmission Distance: 0.6 (or the TIE Fighter!)

Swap Instructions:

• Start with Black

• At layer #23 (1.04mm) swap to Burnt Titanium (for the space background, but you can use anything!)

• At layer #27 (1.2mm) swap to Lemon Yellow

• At layer #39 (1.68mm) swap to Jade White

• At 2.00mm swap to Bambulab Metal (for the TIE Fighter!)

The TIE model itself can be found found here :)