Boost MeIf you found my design unique, I'd really appreciate your support!

Helm Hammerhand's Nazgul mask from Middle-Earth: Shadow of War.

Things you'll need:

- Bit of super glue
- A strap
- Foam for comfort

I tried to keep the mask as close to the original as I could so the eye slits aren't very large but it's still visible :)
Make sure your bed adhesion is good! It's a big and long print.
Comes with multiple variations for cut/uncut files, eyes/no eyes, and strap holders if needed in the raw files.
Strap holder files are also separate if needed, if gluing them on it's recommended to sand the area for better adhesion. 
 

Bottom parts have dense supports because when I initially tried with less, I kept getting failures so I figured more is better than a failed print! As well as stretched cylinders for brim supports as I've yet to see a setting that allows you to change the support brim width.