Minimalist Elastic Cable Management Clip

This is a simple, highly effective cable management clip designed to keep your desk clutter-free. Instead of complex plastic latches that can snap, this design utilizes a standard elastic band (rubber band) hooked around the back to securely hold your cables in place while allowing for easy adjustments.

📥 Features & Variants

I have included two versions of the clip depending on where you want to mount it:

• Flat Back Version: A flush profile that can be universally mounted anywhere (walls, PC cases, or under desks).
• Desk Lip Version: Features a built-in alignment lip that hooks onto the edge of your desk to prevent the clip from shifting or twisting under cable tension.

🛠️ Mounting Options

You can secure these clips to your surface using two methods:

1. Double-Sided Tape / Command Strips: Perfect for a damage-free setup.
2. Screws: The design includes a mounting hole if you need a permanent, heavy-duty hold.

🖨️ Recommended Print Settings

• Material: PLA, PETG, or ABS (PETG recommended if your cables pull tightly).
• Infill: 15% – 20% (Grid or Gyroid).
• Walls/Perimeters: 3 walls for extra strength around the screw hole and hooks.
• Supports: No supports needed! Print it flat on its sidefor the best results.

Note: Just loop any small rubber band or hair tie over the hooks on the back after running your cables through the front.

If you like this design, please consider leaving a ⭐⭐⭐⭐⭐ review and sharing a photo of your print!