Voronoi heart dual slim vase.

A nice decor piece that can be used as a valentines day gift or just show someone special you care.

*The flowers are not part of the model. Just some flowers I had already printed that looked nice in the vase.

Prints in 3 pieces.

1. Base with heart and vase mounts.
2. 2 x Slim vases that fit into the base.

The vases print waterproof in my testing and should for you as well. I have had great luck designing things to use 3 solid walls and having them be watertight.

The Voronoi heart could be tricky if your using unoptimized filaments or printers but I have printed a handful of these on a P1S with Bambu Red PLA without any issues.

Sizing:

• The heart + base
  • 160mm tall
  • 160mm wide
  • 70mm deep
• The vases
  • 140mm tall
  • 14mm inner diameter

Resizing: 

The vase height can be adjusted and it will still fit into the base as long as you only adjust the z-height and not the width. 

If you resize the entire model, the vase may print with less walls. It is designed to print with 3 solid walls to help make it watertight, less walls may change that so keep that in mind.

IMPORTANT NOTE: Do not pull the base with heart off the plate by the heart. It has not happened to me but there is likely a chance if the base is stuck well enough to the print plate you could potentially snap the heart right off the base.