labrax
10 inch rack
network switch holder
- 0.28mm layer, 2 walls, 15% infill
1-disc
PETG
Designer
22
0
The Netgear GS110TP PoE switches are too wide to fit inside the Labrax 10 inch rack, so I created this holder to mount the switch on the side of the Labrax instead. The holder is held on using two bolts of the Labrax frame, which means the bolts need to be a little longer (holder adds 4mm, but you also have to account for the pocket for the bolt head in the Labrax).
The switch has a metal lip at the back and the model has a small cutout so the switch can't move forward out of the rack.
Initially I used zip-ties to keep the switch from moving backwards, but later on designed a clip to keep it in place.
Originality of the Model
The author declares that this work is their personally original model
This model is licensed under the following terms:
Credit must be given to the creator
Only noncommercial uses of the work are permitted
Remixes must be shared under the same license
Models(2)
- switchholder-Body.3mfDesigner
211.69 KB
2026-02-06
switchclip-Body.3mfDesigner3.41 KB
2026-02-06
