simple phone holder bracket to fit in between the 2 cup holders of the MY2022 Opel corsa. (see highlighted position in attached graphic)

The design was intended with a Xiaomi Note 10 without any sleeves/covers/battery extensions or alike in mind. 

The design was intended to use some rotatable fingers in the corners to lock against the neighboring cupholders but the fitment of the first print attempt was already good enough to 

1. not need them
2. not justify reprinting the part without these holding fingers. 

they are there for not included here

print in PETG/ABS/ASA/PC/PCABS/PA due to the temperatures possible in vehicles