Wall mounted cutting board holder for five cutting boards. The holder is designed for four Ikea FINFÖRDELA (https://www.ikea.com/fi/fi/p/finfoerdela-taivutettava-leikkuulauta-vihreae-kirkkaanvihreae-40559680/) and one Ikea LEGITIM (https://www.ikea.com/fi/fi/p/legitim-leikkuulauta-2-kpl-valkoinen-70556703/) cutting boards. The cutting boards are stored at different heights enabling them to be taken out and put back in easily. The holder also holds them at an angle making it easy to take out even the ones closest to the wall. The holder can be installed with two screws through the holes or be screwing two screws (maximum 9mm diameter) on the wall and just sliding the holder in place. The part prints easily without any supports. I printed mine using PETG to prevent permanent damage from warping caused by heavier cutting boards and it has held up without any problems.