A part designed to elevate the top plate and replace the VTX with an o4 Lite (you’ll also need to print a mounting plate to align the screw holes), while preventing grass from entering the frame.

Two variants are available:

• “Basic” version without any decorative patterns
• “More refined” version featuring three grooves along the side (though these supports are slightly more challenging to remove)

There’s no specific orientation required for this part.

Requires M3 × 16 mm screws

The part shown in the photo is Version V1.

V2: Adapted for 5‑inch propellers (compared to 4.8 inches on Version V1)