Hello everyone who owns a CC2 3D printer.


I’m excited to introduce a complete set of accessories that I designed and optimized specifically for the Elegoo Centauri Carbon 2.

Here are the accessories included in the Ultimate Kit:

1. Front Door Handle
You can simply remove the original handle and replace it with the new one easily. It uses the same two original screws included with the printer.

2. Top Cover Handle
A handle for the top lid, making it easier to open the upper cover. It can be attached using 3M adhesive tape or any other glue you have available.

3. Top Lid Hinge
A hinge designed for the top cover, making it much easier to open and close the lid during use. It can be attached using 3M tape or any double-sided tape you have available.

You just need to print it exactly as I set in the file, then remove the supports and bend it to a 90-degree angle. No assembly or extra work is needed.

4. Waste Bin
A minimalist waste container design that attaches securely to the back printer frame

using 8×2 mm magnets.

5. Carbon Filter
A filter that adds an extra layer of protection when printing smelly materials like ABS, ASA, etc. I’ve tested it, and it works very effectively.

You can fill it with activated carbon, or cut and place odor-filter sheets inside

It attaches to the back of the printer using three 20×10×2 mm magnets.

6. A small accessory, but it will make your printer look cleaner. It covers the gap at the back of the printer and also helps secure the 4-pin CANVAS connection cable

That’s everything you’ll get in this design file bundle. You can also download each accessory separately from my profile. Happy printing, everyone!