This model ingeniously blends the characteristics of a vintage propeller-driven aircraft with cyberpunk-style elements, festooning the entire airframe with weaponry. It features two rotating autocannons, two smaller cannons, a large cannon mounted in the center, two rocket pods under each wing, and two aerial bombs suspended beneath the fuselage—resulting in an overwhelming display of firepower.

The model measures 154 x 161 x 71 mm. The propeller and wheels are fully rotatable.

Tools required:

1. Glue
2. Needle-nose pliers
3. Pincettes

Precautions:

• The nose landing gear on one side is equipped with an axle; when removing the support structure, be careful not to snap it off.
• If the cockpit does not fit easily, try using needle-nose pliers to gently trim the bottom edge of the cockpit, creating a 45-degree bevel (only use this method if installation proves difficult).
• Install the wing-mounted rocket pods last. Carefully position each rocket pod, applying a small amount of glue to secure it, then allow the adhesive to cure naturally.
• Follow the assembly manual’s sequence when putting the model together. Some parts may be tight or resistant; in such cases, you may need to manually smooth or modify the surfaces as necessary.
• Before printing, thoroughly clean the print bed, and at higher ambient temperatures, be sure to calibrate the filament feed rate accordingly.
• This model contains many small parts that require gluing for assembly, as explicitly noted in the assembly manual.