Mid-project and realized you're out of large wall plugs? Save yourself a trip to the hardware store! These heavy-duty expansion anchors are designed to hold tight in solid walls.

Designed specifically for a 16mm drill bit and large M12 to M14 screws (or lag bolts).

The set includes 5 lengths:

• 80mm
• 100mm
• 120mm
• 140mm
• 160mm

CRITICAL PRINTING INSTRUCTIONS: To ensure the plug expands correctly and doesn't snap when the screw is inserted, you must print it in the correct orientation:

• Orientation: Print VERTICALLY (standing straight up on the bed).
• Supports: NONE required.
• Bed Adhesion: USE A RAFT. Because these are tall and have a small footprint, a raft is absolutely necessary to prevent them from falling over during printing. (See the included slicer screenshot for an example).