starlink
G3_Router_Holder
Print Profile(1)
- 0.2mm layer, 2 walls, 15% infill
1-disc
PETG
Designer
28
3
Released 2026-03-13
I want to find a good way to ceiling mount the G3 Starlink Router . A ultra clean setup . . should print with PETG not PLA . Because it need a bit flexible to push in the Router . If you not using a Ethernet Cable
there will be no cable seen in the out side .
Originality of the Model
The author declares that this work is their personally original model
This model is licensed under the following terms:
Credit must be given to the creator
Only noncommercial uses of the work are permitted
Models(2)
G3_Router_Holder.stlDesigner
57.11 KB
2026-03-12
- G3_Router_Holder.3mfDesigner
45.06 KB
2026-03-12
No more
