Pikachu
tin
Boko Dream
- 0.2 mm layer height, 2-wall structure, 3% infill density
7-disc
PLA
Designer
81
23
The default print height is approximately 16 cm, which is the minimum dimension required for the piggy bank—any smaller and coins won’t fit inside. The single disk can be scaled up to meet your specific needs. To remove the support structure within the piggy bank cavity, simply use long‑nose pliers or a screwdriver to gently tilt the support once; this will cause the entire piece to dislodge. Then, use pliers to crush the support completely, allowing it to be fully extracted.
Originality of the Model
The author declares that this work is their personally original model
This model is licensed under the following terms:
This work is licensed under a Standard Digital File License. Digital files have a strict non-commercial, personal use only license.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital file or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including remixes of this object). You can not host these files on other digital platforms, web stores or cloud repositories. The objects may not be used in any way whatsoever in which you charge money, collect fees.
Models(1)
- 皮卡丘存钱罐.3mfDesigner
4.47 MB
2025-10-07
