Time and material saving
The model has been designed to enable fast, simple and material-saving printing. There are larger and more detailed models, but these require a much larger print area or the printing of several parts.

Improvements
I have removed the finest, hard-to-print details and added larger, better printable structures. The printing time is therefore shorter and the stability of the details and the entire model is greater.

Print
I strongly recommend printing with a maximum layer height of 0.2mm so that the fine details of the buildings are more visible. No supports required!

I do not recommend scaling the model down, as important details could be lost.

I printed in PETG with 0.3mm layer height with 3 perimeters. 25% Infill, lower infill should work.

Do you like my work? I would be very happy if you would support my work on Ko-fi.

Differences of the remix compared to the original

• removed the finest, hard-to-print details and added larger, better printable structures
• adjusted the scale of some buildings and moved buildings
• Further buildings added
• removed some buildings