The F22 - Holo Raptor

A miniature of a cutting-edge F-22 Holo Raptor stealth aircraft. I spared no expense and equipped it with advanced holographic shield technology that cloaks both the front and cockpit canopy, rendering it invisible to enemy detection systems. 

The design features triangular radar-deflecting panels that maximize stealth capabilities by scattering radar waves. For defense, it utilizes revolutionary nano-projectile systems capable of intercepting incoming missiles with pinpoint precision. 

Powered by a top secret futuristic gravimetric drive (expect a visit from USAF if you print this model)…

… this aircraft achieves unparalleled propulsion, allowing for seamless maneuverability in both atmospheric and space environments. Additionally, it incorporates an oxygenic nano carbon atomizer, which continuously harvests oxygen molecules from its surroundings to sustain the pilot and systems, enabling virtually infinite flight duration without refueling.

SPECIAL NOTE!!!!!

Adhesion is CRUCIAL with this model. The jaw has very little surface area, I didnt check the first layer and mine got messed up. I added some mouse ears that should solve the issue though, but keep a close eye on the first few layers. If the problem persists, I will try something else.

Also, try not to use the Super Tack plate, taking the print off may damage the strings. Most models with strings only use a single 0.24 layer high string, I use two. That way, if one fails, the other usually does not. There are other variations on the way, such as AMS painted, strings different color and support for the lamp and waterproof pucks. 

To light it you will need the standard 3AAA RGBW pucks, either from Aliexpress or bambu lab. 

Here is a link from a seller I used before, you get 3 pucks for a euro

- Search “rgbw pucks aaa” on aliexpress and pick the best deal for you. It shouldnt cost more than a euro each

Relatively simple, assemble the two halves using an assembly jig in the profile, it is basically two rings that will fit exactly to the two halves, just make sure you put a paper down so the glue doesn't leak and ruin your table (ask me how I know). There are nubs in the provided bases and it will keep it in place for a desktop stand, but carrying it around without gluing it, is not advised… if you are happy with it and do not wish to reuse the base for my other models, go ahead and glue it.

Also, DO NOT change layer size because then the mid air strings may fail. Any issues, let me know.