INTRODUCTION

v2 of my Magnet Insertion Tool, with

• optimized Tip size
• trigger suspension
• self reloading Magnet Magazine

Compatible with Magnets of this size:

5x1mm 

(check if your magnets are really about 1mm thick. some people ordered 1mm magnets but only got 0.8mm magnets which may cause some troubles

FILAMENT

i used this PLA+ but any other Pla should work as well

PLA+ (reflink)

Other Hardware you need:

• 2x M3x6mm
• 3x M3x10mm
• Rubberband
• 3x Magnets of selected size

ASSEMBLY

There is a PDF attached to the files with assembly instructions as well as some simple Assembly steps shown in the Video

I reccomend printing 2 tools. 1 for each pole of the magnet. I printed one in Red and one in blue.

Support my work by becoming a PATREON

or BUY ME A COFFEE