:

💀 Skulls Bookmark – HueForge Multi-Color Design

A gritty, layered piece that brings haunting elegance to your reading sessions. This bookmark features a vertical stack of skulls rendered in sharp tones using the HueForge method. Crisp contrast, minimal waste, and a fast, clean print—perfect for book lovers with a darker side.

🧵 Manual Color Change Instructions – No AMS Needed
This model uses 4 filament colors and is fully printable on any single-extruder printer.
Pre-set pause points are included so your printer will stop at the correct layers for manual swaps.

🎨 Colors Used (in order):

1. Black – BambuLab Black (TD: 0.3)
2. Gray – BambuLab Tough Gray (TD: 1.8)
3. Light Gray – BambuLab Basic Gray (TD: 2)
4. Bone White – BambuLab Bone White (TD: 5)

⏸️ Swap Layers:

• Start with Black
• At layer #11 (0.96 mm) → swap to Gray
• At layer #16 (1.36 mm) → swap to Light Gray
• At layer #19 (1.6 mm) → swap to White (for the rest)

📐 Model Info:

• Size: 42 mm × 145 mm
• Max Depth: 2.4 mm
• Actual Depth: 2.5 mm
• Minimum Printable Depth: 0.48 mm
• Best Layer Height: 0.08 mm (Base layer: 0.16 mm)
• Infill: 100%
• Supports: None

🛠️ Print Tips:

• Brim recommended for bed adhesion.
• For AMS-free printing: insert pause manually on the right-side slider in your slicer at the above layers.
• Works great on both Bambu Studio and OrcaSlicer.