Filament spool holder to mount on top of the Sculpto printer.

Two versions: Sculpto+ and Sculpto original.
The handle screws are different on the two models so make sure to print the version that fits your model. 'Sculpto+' and 'Sculpto ori' is engraved to help telling them apart.

Simply:
-Print directly from Sculpto app. (~7 hours)
-Unscrew the two screws of the handle
-Slide the two spool holders on the handle from each side.
-Reposition the handle back on the machine.
-Mount the screws again.
-Place the spool within a filamentspool and place on top of the two filament holders.

Thoughts on the design:
-It frees up table-space next to the printer by moving the filament on top.
-The filament string doesn't seem to break in between use of the printer as I have often experienced with a normal spool holder next to the printer.
-The weight doesn't seem to put the printer off balance but if so, check the 'feet-knobs' underneath the printer to make sure they are placed optimally.

The filament holders take off 3 mm of height on the steel bars as it goes slightly below the position of the handlebar. It should be of no importance as the printers steel bars are higher (17 cm) than the printer is able to be set to print (16 cm). Thus the printer will not be able to go this high anyway.

Feel free to improve the design all you want. I'm sure things can be tweaked more.

The file includes a combined stl with all 3 elements (two filament holders and one spool) and two separate stl-files (the filament holder seperate and the spool seperate) if you wish to print one element at a time for best result.
Print with no support, strong and on fine quality for best fit.

The latest files have smaller 'forks' for the filament spool. Furthermore 'Sculpto+' and 'Sculpto ori' is engraved to help telling them apart.

Note: The old versions have been removed to avoid confusion.

Please consider leaving a small tip if you find this filament holder useful. ( :