I remixed the excellent work antiping did on his toppers. I increased the height of the loose cobblestones because I want more depth to show off the SpeedPaints. I also added some features to allow it to be printed directly onto the resin bed. I added a small cutout at the base to prevent suction and I adjusted the interior to allow it to be printed without supports.

I was able to print 85 of these in a single batch print without any problems. NOTE: To ensure good adhesion, I set the cap Z height to -0.50 mm.

One issue I had after my first print was that a lot of resin got trapped in the hollow of the cap. To alleviate this, I added two drain holes so the resin can escape after printing.