Designed a new pressure plate for my old Saitek joystick that had a lot of wobble on neutral position.
This was due to the original pressure plate shaft guide tapering out near the top, creating slack between the guide and the joystick shaft - as a result I got a lot of wobble at neutral, forcing to increase the deadzone.
This worsened to the point I had to add a significant ammount of deadzone (about 10%), that made fine inputs nearly impossible.
Recommend using the model orientation as is, if using FDM, for the best possible finish on the contact surface - it also helps bumping the slicer to 0.1mm layer height
Didn't test it on rebranded Logitech hardware though, it should fit if dimensions didn't changed meanwhile