Pixel Art
Filament change
artsofwin
- 0.2mm layer, 2 walls, 15% infill
1-disc
PLA
Designer
2
0
How does it feel to be an ancient artist?, by arts.of.win, with 2 filament changes
---
Pseudo 3D model based on the Pixel Art "How does it feel to be an ancient artist?" by "arts.of.win"
With 2 filament changes for a total of 3 different colors
This print must to be slice with "Initial Layer Height" and "Layer Height" = 0.20 mm (unless there is a change in scale)
Except change of scale and/or layer height befor slicing.
You need to add 2 "filament change" (g-code "M600") or "pause" (g-code "M0") depending on your printer/firmware to change filament.
A change of filament every two layers.
Start with : White filament until Z0.40
Switch to : Orange or ... filament until Z0.80
Switch to : Black filament until Z1.20, the end of the print.
Credits :
- Pixel Art "How does it feel to be an ancient artist?" by "arts.of.win" https://www.instagram.com/arts.of.win/ from Instagram post https://www.instagram.com/p/C2H9Tg2x8Xh/
Happy printing.
Originality of the Model
The author declares that this work is their personally original model
This model is licensed under the following terms:
Credit must be given to the creator
Only noncommercial uses of the work are permitted
Remixes must be shared under the same license
Models(2)
- ES1516_ECC2_SilkPLA_0.20mm_How does it feel to be.3mfDesigner
292.77 KB
2026-07-22
How+does+it+feel+to+be_Dist02.stlDesigner1.31 MB
2026-07-22
