Sen is a family of 3D printable planters for indoor or outdoor use for your plants.

You can use them directly as planters or insert standard plastic pots as their sizes allow for the incorporation of these sizes of planters:

● 1: 10.5 cm diameter x 9 cm high.

● 2: 12 cm diameter x 11 cm high.

● 3: 14 cm diameter x 13 cm high.

Each size also has a matching base to prevent possible water leaks. So you can water your plants with peace of mind :)

3D printing settings

For the body (sen) you have to indicate the following parameters in the cutting program (I used Cura):

• Filling: 0%

• No support

• No adhesion

• Layer height: 0.2 mm

• Top layers: 0

• Lower layers: 5 (minimum)

• Wall line count 3 (minimum)

• Nozzle size: 0,4 mm

• Nozzle temperature: 200°C

• Shrinkage: Yes

*To increase tightness Increase the number of walls, decrease the print speed and increase the layer height.

**You can also try vase mode if you have a larger nozzle (>0.4mm), increasing the temperature (+5°C) and decreasing the print speed (<30 mm/s).

For the matching base (arcsen) print without using the vase mode following these parameters:

• Filling > 20%.

• No support

• No adhesion

• Layer height: 0.2 mm

• Top layers 4

• Lower layers 4

• Number of wall lines 3

• Nozzle size: 0.4 mm

• Nozzle temperature: 200°C

• Shrinkage: Yes

*To increase tightness Increase the number of walls, decrease the print speed and increase the layer height