Say goodbye to soggy, smelly sponges. This drip tray features a functional wave pattern on the bottom that lifts your sponge (or soap bar) slightly up, allowing air to circulate underneath and water to flow away freely.

Key Design Feature: The front of the holder has a dedicated drainage spout/opening. Position this edge over your sink, and excess water will naturally drain out, keeping your countertop dry and your sponge hygienic.

The Set Includes 2 Sizes:

• Standard (95x65mm): Perfect for standard kitchen sponges. Fits items up to ~95x65mm comfortably.
• Large (115x85mm): Great for larger scouring pads or big bars of artisanal soap. Fits items up to ~115x85mm. (Note: Due to the open front design, you can technically squeeze in items about 5mm larger than these dimensions if needed).

Printing Instructions:

• Material: PETG or ASA are recommended because they handle moisture and cleaning chemicals better than PLA (though PLA works fine for a while).
• Supports: None required.
• Infill: 15-20%.
• Watertight: Ensure your "Flow" is calibrated or increase wall count to 3 to ensure the tray doesn't leak.