Second version of my crappy model of a piggybank with working flush (it opens the seat up)

---

If you want to sell prints of this models you can buy a commercial license

Check my LinkTree in my bio

---

You will need to print:

- 1 Base - default: ToiletBox-v2_BANK_base

- 1 Cover - default: ToiletBox-v2_BANK_cover

- 1 Flush (unless printed No-Flush version) - ToiletBox-v2_flush

- 2 Rods for hinge (or just some filament string) - ToiletBox-v2_rod
- 1 Seat - default: ToiletBox-v2_seat
- 1 Spring (optional) - ToiletBox-v2_spring-optional

More different options listed below

---

- BANK - as a piggy bank, flush is opening the seat - default and recommended setup

- SECRET - normal box with another secret stash under top cover - no hole for coin

- BANK-no-flush - as a piggy bank without opening mechanism

- SECRET-no-flush - same as SECRET but without a flush and with more space in secret stash

- BANK-SOLID - solid model of piggy bank, only one part. You will need to break it to gather coins from the inside. - WARNING: print needs a good cooling to look good

All of the models, except BANK-SOLID, are also in BIG versions wich is an optimized 150% size of an original model (wich gives 3x more space for coins) - better resolution, with walls still the same thickness as original (wich is 4x 0.4mm). You can resize it bigger if you want

If you want a model between 100% and 150% size you should resize original model up, not BIG model down

You will need a 1cm of 1.75 filament for each hindge
OR two printed rods (in files)

Both should work without any glue

You can use SECRET with a cover with a hole (BANK_cover) to use as a small piggy bank and bigger storage under seat for something else

There are 4 versions of a cover

with a hole for coins (BANK_cover)

without any hole (SECRET_cover)

with big hole (BANK_cover-big-hole) - as big as space below

with even bigger hole (BANK_cover-big-hole_no-flush) - to use with no-flush version of base

Last two can be used to store something bigger than coins in this Toilet Box (without the need of opening the seat)

Seat is in two versions, original, more rounded, and streight wich is more ‘blocky’ but elegant

No-flush base models can be used only with no-flush seat models

Printed spring is not needed for a mechanism to work, but it may help a little. You can also use a spring from a pen instead of a printed one

---

Video with printing timelapse, assembling and using

https://www.instagram.com/p/Cz4FUv5NW8R/

---

Printing tips

Made for 0.4mm nozzle

I printed it with 0.2mm layer hight

2 walls

No infill (you can use some for easier printing and stronger model)

5 top and bottom layers

No supports needed

---