Description

I printed this Christmas tree stand using only PETG, without any additional screws or other materials.

The wedges are slightly flexible and adapt very well to the tree.

I attached a float to the water tank so you can check the water level at any time.

Please note that to ensure the stand is waterproof, I strongly recommend painting the inside and 

the float with waterproof paint!

I created two print profiles: one for a small diameter of approximately 55mm - 25mm.

                                                                 large diameter of approximately 80mm - 40mm.

After inserting the three base feet, place the tree inside.

Then gently insert the wedges around the tree, and only now

press them firmly by hand. 

The tree stays upright!

Now insert the float or water level indicator.

Now fill with water until the float shows “FULL”.

Have fun printing!