Thank you all for your support. I'm always happy to hear your opinions and suggestions for new models. So please share them in the comments.

You can offer me a coffee and support my work here >>> https://ko-fi.com/drakeforge3d  If you like my work and want to support me, I appreciate any support. The website also includes a commercial license that allows you to sell all my existing models.

Haunted Pumpkin House 

Step into the eerie spirit of Halloween with this wickedly charming Haunted Pumpkin House! Printed in grey-blue PLA using FDM technology, this model captures the essence of a creepy jack-o’-lantern turned into a tiny haunted dwelling.

The sinister carved face grins menacingly, while delicate spiderweb details fill the windows, adding a chilling touch to the design. A small door at the base invites only the bravest souls inside, while little pumpkins complete the haunted yard.

 Designed for smooth printing with a minimal amount of supports that are easy to remove, this model is as practical as it is spooky.

Available in two sizes to fit your Halloween setup:

• 110 mm height – perfect for tabletop displays.
• 170 mm height – a larger, more haunting centerpiece.

Whether you want to decorate your home, create a spooky village, or just add a little frightful fun to your shelf, this Haunted Pumpkin House will surely cast a spell on your Halloween season! 

 Guide

Each of my models is printed 2-3 times before releasing the profile. So if you have a problem with printing:

1. DRY THE FILAMENT
2. CHANGE THE NOZZLE TO A NEW ONE.

Recommendations  Guide : In case of a problem with damage to the supports, I recommend reducing the printing speed of the supports by 30-50% and the travel speed to 400mm/s. When removing the supports, I recommend first cutting off the pieces right next to the character, but not removing them, just cutting them off. Remove the remaining larger pieces and only then detach the remaining smaller pieces. This reduces the risk of damaging delicate elements.

• Please note that if you use a different filament than the recommended one, the effect may be different from my print. For example, printing in silk PLA will look better but the supports and the print itself will be more brittle and less durable.

   

   

  Recommendations:

• 
   
• 0.08-0.2. In the event of changing the original height, the height of the supports should be changed.
   

• PLA+HS, PLA+, PLA, PLA silk Recommended materials are listed in order from best to good.

   

• Clean the plate thoroughly before printing.
  Make sure the filament is dry and free from dirt. This can damage the print or weaken the support