Picture source - author: Brett Voutier  @brettvoutier

Then used HueForge v0.8.1 to create the model.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm. 

You may print at higher layer heights below the Min Depth of 0.48mm. The Max Depth is 2mm and the Actual Depth is 1.84mm.

In print profile is modesl size 150x150mm, you can download also same or bigger - 200x200mm size STL file.

Or only modify the X and Y dimensions. Do not adjust the height (Z) in your slicer! The layers would not be correct. 

It is possible to print without material system by manually changing the filament (setting filament change or pause) in the slicer, depending on your printer and sw support.

These were my settings and colors for my print that you see in the picture. Your results may be depending on the filament you use.

Filaments Used:
PLA Elegoo+ Black Transmission Distance: 0.3
PLA Devil Design Navy Blue  Transmission Distance: 1.6
PLA Sunlu META Grey  Transmission Distance: 3.6
PLA Elegoo + White  Transmission Distance: 6
This print uses 4 unique filaments

Swap Instructions:
Start with Black
At layer #9 (0.8mm) swap to Navy Blue
At layer #11 (0.96mm) swap to Grey
At layer #12 (1.04mm) swap to White for the rest.
 

*  Info For Centauri Carbon!!!  Officially supports a layer height of 0.1mm - but in system 0.08 (adaptive layer value). So you can set it for printing and everything works correctly!